Anschutz Model 2007/13 Precision Barrel
PRICE: $355 plus shipping
Matt Emmons wins OLYMPIC
GOLD in Athens using Lilja Anschutz drop-in barrel!
Matt says: "Bar none, the best shooting gun I have
ever shot. I refer to it as the laser." For the
complete story - Click Here
Barrel Data
- Stainless steel .900" diameter straight and 21" long.
Weight: 3 pounds 8 ounces (Note: We usually have some longer un-crowned
barrels in-stock that can finish as long as 27". We can crown
them and deliver in less than a week.)
These barrels are a true match-grade barrel, we only have one grade
for all of our barrels, our best. All of these barrels are made
from 1" diameter 416 alloy rifle-barrel-quality stainless steel.
Every barrel is drilled, reamed and rifled in our shop followed
by a stress relieving heat treatment operation. They are then hand-
lapped for a superior internal finish and diameter uniformity. With
these drop-in barrels we then turn the shank end of the barrel to
the proper dimensions and cut a true
match chamber.
The barrel is then cut to final length and crowned with an 11 degree
target-type crown. Each barrel is then polished to a 600 grit exterior
finish and then our name and the cartridge designation is engraved
on the barrel. And lastly the finished barrel receives a final inspection
and is sealed in a 6 mil poly tube and placed on the shelf.
Accuracy with the Anschutz barrel is excellent. At 50 yards with
the Bull barrel 5-shot groups in the .2's and often better can be
expected.
Drop-in barrels do not require any special gunsmithing. Directions
for installing the barrel are furnished with each barrel. These
instructions can also be found directly below. If you do not feel
qualified to install your new drop-in barrel we can do so for a
$25 charge.
Note: We do not make a drop-in type barrel for any of the other
Anschutz models, just for the 2007/13. One of our barrels can be
fit to any other Anschutz receiver by a gunsmith. We do not do that
installation.
Installation Instructions for
Anschutz 2007/13
To remove original barrel:
- Backoff single 3mm set screw on bottom of receiver.
- Loosen (3) 4 mm socket head cap screws.
- Pull original barrel out of action.
To install new barrel:
- Slide barrel into receiver until it contacts loading ramp.
- Place Go Gauge in chamber and close bolt.
- Tap barrel from muzzle end to ensure barrel is up against the
Go Gauge. This step is very important.
- Tighten 3 mm set screw on bottom of receiver.
- Tighten (3) 4 mm scoket head cap screws.
We offer .043" Go Gauge made
by Pacific Precision for $19.
Anschutz is a registered trademark of J.G. Anschütz GmbH,
Ulm, Germany
|
